Cover - Footwell - Driver (RHD) (Remove and Replace)
Correction code
1405030002
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Open the RH front door and lower the RH front window.
- Move RH front seat backward.
-
Remove the push clip securing the RH footwell duct from the RH footwell cover.
-
Release the clips (x6) and remove the
driver footwell cover from the vehicle.
-
Disconnect the electrical harness from
the puddle light connector, and then remove the the driver footwell cover from the
vehicle.
Install
-
Connect the electrical harness to the puddle light connector.
-
Install the clips (x6) that attach the
driver footwell cover to the vehicle.
-
Install the push clip securing the RH footwell duct to the RH footwell cover.
- Move the RH front seat to the original position.
- Raise the RH front window and close the RH front door.