2025-04-11

Connector - Pedestrian Warning Speaker - Rear (CN) (Remove and Replace)

Correction code 1710083602 FRT 0.35 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the rear fascia. See Fascia Assembly - Rear (Remove and Install).
  2. Disconnect the electrical connector from the pedestrian warning speaker.
  3. Remove the clip that attaches the harness to the pedestrian warning speaker.
  4. Remove the connector locking cover, and then press down on the pins (x2) while pulling the harness downwards to remove the connector from the vehicle.

Install

  1. Insert the pins (x2) into the connector, and then install the connector locking cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a pull-push-pull test to verify the pins are fully seated.
  2. Install the clip that attaches the harness to the pedestrian warning speaker.
  3. Connect the electrical connector to the pedestrian warning speaker.
  4. Install the rear fascia. See Fascia Assembly - Rear (Remove and Install).