30/08/2024 00:21:44

Wheel Disposal (Rework)

Correction Code 34015007 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Note
This procedure is performed to make sure that a wheel that was replaced for any reason cannot be reused.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Wear appropriate personal protective equipment (PPE) including cut-resistant gloves and safety glasses when performing this procedure.

Procedure

  1. Put the wheel on a bench with the valve hole facing you.
  2. Measure approximately 3 cm (1.2 in) from the center of the valve hole, and then make a mark with a paint pen.
  3. Use a 10 mm drill bit to drill a hole at the marked position.
  4. Dispose of the wheel at the appropriate waste location.