17/10/2023 18:48:41

Trunk Hinges And Fittings -Overslam Bump Stop (Remove and Replace)

Correction code 1133070042 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Apply masking tape around the bump stop to protect the paint.
  3. Use a plastic trim tool to remove the bump stop.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Install

  1. Install the bump stop to the vehicle.
  2. Remove the masking tape from the vehicle.
  3. Close the liftgate.