17/10/2023 18:49:15
Seal - Trunk (Remove and Replace)
Correction code
1170040012
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the trunk sill trim. See Trim - Trunk Sill (Remove and Replace).
-
Release the trunk seal from the trunk
perimeter, then remove the seal from the body.
Install
- Align the line on the trunk seal to the striker.
-
Install the trunk seal to the
perimeter of the trunk.
Tip: Tap the trunk seal with a rubber hammer and use a plastic trim tool to fully install the trunk seal to the body.NoteMake sure the bottom of the seal is tucked into the rear fascia.
- Install the trunk sill trim. See Trim - Trunk Sill (Remove and Replace).