Isolator - Rear Spring - Lower - LH (Remove and Replace)
Correction code 3115020022 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
- Remove the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
- Remove the LH rear suspension cover. See Cover - Rear Suspension - LH (Remove and Replace).
- Remove the LH rear suspension spring. See Coil Spring - Rear - LH (Dual Motor) (Remove and Replace).
- Remove the LH rear suspension spring lower isolator.
Install
-
Install the LH rear
suspension spring lower isolator to the spring.
NoteAlign the stop of the spring lower isolator to the end of the spring, as illustrated.
- Install the LH rear suspension spring. See Coil Spring - Rear - LH (Dual Motor) (Remove and Replace).
- Install the LH rear suspension cover. See Cover - Rear Suspension - LH (Remove and Replace).
- Install the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
- Install the LH rear wheel. See Wheel Assembly (Remove and Install).