23/05/2024 07:50:23

Hose - Chiller to HV Battery (LHD) (Remove and Replace)

Correction code 1830020052 FRT 2.70 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
  2. Remove the center caps (x2) of the front wheels, and loosen the nuts (x10) on the LH and RH front wheels.
  3. Open all doors and lower all windows.
  4. Unlock the vehicle gateway. See Gateway Unlock.
  5. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Thermal > Coolant System > Coolant Fill/Drain > Run, and then allow the routine to complete.
    Tip: The routine has a 5-hour time limit.
  6. Disconnect the LV power. See LV Battery - Li-lon (Disconnect and Connect).
  7. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  8. Perform Vehicle HV Disablement Procedure. See Vehicle HV Disablement Procedure.
  9. Lower the front subframe assembly from the vehicle. See Subframe Assembly -Front (Remove and Replace).
  10. Release the clips (x5) to remove the chiller to battery hose from the vehicle.