Lamp - Trunk (Remove and Replace)
Correction code
1530030082
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the trunk garnish. See Garnish - Trunk (Remove and Replace).
-
Slightly lift the upper part of the LH trunk side trim to access the puddle
light.
-
Disconnect the electrical connector from the puddle light.
-
Release the tabs (x4) that attach the LH puddle light to the vehicle.
-
Remove the LH puddle light.
Install
-
Install the tabs (x4) that attach the LH puddle light to the vehicle.
-
Connect the electrical connector from the puddle light.
- Move the LH trunk side trim back to its original position.
- Install the trunk garnish. See Garnish - Trunk (Remove and Replace).