19/06/2023 21:10:48

Cooling System (Check and Fill)

Correction code TBD 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Procedure

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Wear appropriate personal protective equipment (PPE) including a full face mask when performing this procedure.
  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the coolant bottle cap.
  3. Fill the coolant to the proper level.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the coolant level is at the "Max" line.
  4. Install the coolant bottle cap.
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).