17/10/2023 18:49:14

Seal - Inner Belt - Rear Door - LH (Remove and Replace)

Correction code 1170010012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH rear door puddle light. See Puddle Lamp - Rear Door (Remove and Replace).
  2. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  3. Release the clips (x6) that attach the rear and front of the inner belt seal to the rear door, and then pull up to release the inner belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the clips that remain in the door, and then install the clips into the rear and front of the inner belt seal.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.