2026-03-02

Camera - Interior (LHD) (Remove and Replace)

Correction code 1724010012 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-02: Updated calibration steps to use ServiceUI.
  • 2025-03-25: Added camera connection test routines.

Torque Specifications

Table 1. Torque Specifications: Camera - Interior (LHD) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the interior camera to the camera upper cover
0.8 Nm (7 lbs-in)
  • Torx T10 bit
 Replace 1919198-00-A

Remove

  1. Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
  2. Remove the upper camera cover. See Camera Cover - Upper (Remove and Replace).
  3. Remove and discard the bolts (x2) that attach the interior camera to the camera upper cover, and then remove the interior camera.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit

Install

  1. Secure the interior camera into the tab on the upper camera cover.
  2. Install new bolts (x2) that attach the interior camera to the upper camera cover.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 bit
  3. Install the upper camera cover. See Camera Cover - Upper (Remove and Replace).
  4. Unlock the vehicle gateway. See Gateway Unlock.
  5. Run PROC_DAS_X_CLEAR-CALIBRATIONvia Toolbox: (link)via Service Mode:
    • Driver Assist ➜ Cameras ➜ Clear Camera Calibration
    • Driver Assist ➜ Driverless ➜ Clear Calibration
  6. Run PROC_DAS_X_CALIBRATE-CAMERAvia Toolbox: (link)
  7. Exit Service Mode Plus. See Service Mode Plus.