17/10/2023 18:48:09

Bracket - Rear - Center (Remove and Replace)

Correction code 1001040062 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Rear - Center (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x5) that attach the rear center bracket to the body
4 Nm (2.9 lbs-ft)
  • 4 in extension
  • 10 mm socket
  • Ratchet/torque wrench
 Reuse Bolt is patched.

Remove

  1. Remove the rear fascia. See Fascia Assembly - Rear \(Remove and Install\).
  2. Remove the clip that attaches the BLE to the rear center bracket.
  3. Release the clips (x5) that attach the electrical harness to the rear center bracket.
  4. Remove the bolts (x5) and clips (x2) that attach the rear center bracket to the body.
    Tip: Use of the following tool(s) is recommended:
    • Cordless hex driver
    • 10 mm socket
  5. Remove the rear center bracket from the vehicle.

Install

  1. Install the bolts (x5) and clips (x2) that attach the rear center bracket to the body.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 4 in extension
    • 10 mm socket
    • Ratchet/torque wrench
  2. Install the clips (x5) that attach the electrical harness to the rear center bracket.
  3. Install the clip that attaches the BLE to the rear center bracket.
  4. Install the rear fascia. See Fascia Assembly - Rear \(Remove and Install\).