17/10/2023 18:56:07

Brake Shield - Rear (Base Brakes) - LH (Remove and Replace)

Correction code 3301020072 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Brake Shield - Rear (Base Brakes) - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the LH rear brake dust shield to the knuckle
8 Nm (5.9 lbs-ft)
  • Torx T30 socket
  • Cordless Ratchet/Impact Driver
  • 4 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the LH rear hub. See Hub - Rear - LH (Remove and Replace).
  2. Remove the bolts (x3) that attach the LH rear brake dust shield to the knuckle, and then remove the dust shield from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Cordless Ratchet/Impact Driver
    • 4 in extension
    • Ratchet/torque wrench

Install

  1. Position the LH rear brake dust shield to the vehicle, and then install the bolts (x3) that attach the dust shield to the knuckle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Cordless Ratchet/Impact Driver
    • 4 in extension
    • Ratchet/torque wrench
  2. Install the LH rear hub. See Hub - Rear - LH (Remove and Replace).