17/10/2023 18:56:38
Seal - Axle - Output - Front Drive Unit (3DU) (Remove and Replace)
Correction code 3901010082 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 1498673-00-A KIT, CABLE AXLE REMOVER, MS/MX/M3
- 1096075-00-A Tool, Hub Puller, Hydraulic
- 1131206-00-A Install Tool, Output Seal, Model 3
- 1454928-00-A TOOL, SEAL PULLER, ADJUSTABLE, MS/MX/M3
Remove
- Remove the LH front drive unit halfshaft. See Halfshaft - Front Drive Unit - LH (Remove and Replace).
- Use an adjustable seal puller tool to remove the LH front drive unit differential-halfshaft assembly oil seal.
Install
- Use an output seal install tool and a dead blow hammer to install the new LH front drive unit differential-halfshaft assembly oil seal. Make sure the seal is flush with the front drive unit.
- Install the LH front drive unit halfshaft. See Halfshaft - Front Drive Unit - LH (Remove and Replace).