2023-11-16

Latch - Cinch - Trunk (Remove and Replace)

Correction code 1120020012 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the trunk latch cover. See Cover - Latch - Trunk (Remove and Replace).
  2. Disconnect the electrical connector from the latch.
  3. Remove the bolts that attach the latch to the trunk lid, and then remove the latch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:

Install

  1. Position the latch and loosely install the bolts that attach the latch to the trunk lid.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 4 in extension
    • 10 mm socket
  2. Connect the electrical connector to the latch.
  3. Close the trunk to check gap/flush and, if necessary, perform adjustments.
  4. Install the trunk latch cover. See Cover - Latch - Trunk (Remove and Replace).