27/05/2024 20:31:55

Cover - Phase Out - Rear Drive Inverter (4DU) (Remove and Replace)

Correction code 4001030012 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
  2. Open all doors and lower all windows.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect LV power. See LV Battery - Li-lon (Disconnect and Connect).
  5. Remove the 2nd row lower seat cushion, See Seat Cushion - 2nd Row (Remove and Replace).
  6. Perform Vehicle HV Disablement Procedure. See Vehicle HV Disablement Procedure.
  7. Remove the rear aero shield panel, See Panel - Aero Shield - Rear (Remove and Replace).
  8. Remove and discard the label from the phase cover.
  9. Remove the bolts (x2) that attach the rear drive unit phase out cover to the rear drive unit gearbox, and then use a plastic trim tool to remove the cover from the gearbox.
    Tip: Use of the following tool(s) is recommended:
    • External Torx Plus EP10

Install

  1. Inspect the condition of the phase out cover and O-rings. If the cover has less than 6 O-rings, or if the O-rings or cover are damaged, discard the cover and use a new cover.
  2. Lightly lubricate the rear drive unit gearbox phase out cover bores with KAF 1 fluid, and if a new phase out cover is to be installed, lightly lubricate the O-rings of the cover.
  3. Install the phase out cover into the rear drive unit gearbox, and then install the bolts (x2) that attach the cover to the gearbox.
    14 Nm (10.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • External Torx Plus EP10
  4. Install a new phase out cover label.
  5. Remove the rear aero shield panel, See Panel - Aero Shield - Rear (Remove and Replace).
  6. Install the 2nd row lower seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).
  7. Connect LV power. See LV Battery - Li-lon (Disconnect and Connect).
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  9. Raise all windows and close all doors.
  10. Remove the vehicle from the lift.