21/03/2024 12:22:53

Rear Fascia Light - LH (Remove and Replace)

Correction code 1740020012 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Rear Fascia Light - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the rear upper fascia to the rear fascia
3 Nm (2.2 lbs-ft)
  • Ratchet/torque wrench
  • 10 mm socket
 Reuse
Bolts (x2) and clip that attach the LH rear fascia lamp to the rear fascia
2.5 Nm (1.8 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • Torx T25 socket
  • Torque Wrench Hexagon - 1060071-00-A (for installation only)
 Reuse

Remove

  1. Remove the rear fascia and place it on a padded surface. See Fascia Assembly - Rear \(Remove and Install\).
  2. Remove the bolt that attaches the rear upper fascia to the rear fascia.
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 10 mm socket
  3. Disconnect the LH rear fascia lamp connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  4. Remove the bolts (x2) and clip that attach the LH rear fascia lamp to the rear fascia.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx T25 socket
    • Torque Wrench Hexagon - 1060071-00-A (for installation only)
  5. Remove the LH rear fascia lamp assembly.

Install

  1. Install the bolts (x2) and clip that attach the LH rear fascia lamp to the rear fascia.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx T25 socket
    • Torque Wrench Hexagon - 1060071-00-A (for installation only)
  2. Connect the LH rear fascia lamp connector.
  3. Install the bolt that attaches the rear upper fascia to the rear fascia.
    3 Nm (2.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 10 mm socket
  4. Install the rear fascia. See Fascia Assembly - Rear \(Remove and Install\).
  5. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  6. Click the Actions tab, type "TEST-SELF_VCRIGHT_REAR_FASCIA-LIGHTS" into the search field, click via Toolbox: (link), click Run, and allow the routine to complete.
  7. Disconnect the laptop from the vehicle.
  8. Remove the lift arms from below the vehicle.