Puddle Lamp - Center Console (Remove and Replace)
Correction code
1519010242
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
- 2025-02-08: Updated the original removal method to directly prying the puddle lamp out.
Remove
- Open the LH front door and lower the LH front window.
-
Fully retract the media bin lid and the cup holder lid on the center console to the
locked position.
-
Use a plastic trim tool to release the
clips (x4) and pry the puddle light outward, and then disconnect the electrical
connector.
Install
-
Connect the electrical connector, and then clip the puddle light into the center
console.
- Close the media bin lid and the cup holder lid.
- Raise the LH front window and close the LH front door.