10/04/2024 20:23:00
Seal - Body - Side - Rear - Primary - RH (Remove and Replace)
Correction code 1170010082 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-04-10: Updated the LH primary rear side body seal images and the number of the clips.
Remove
- Remove the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
- Release the clip that attaches the LH primary rear side body seal to the upper B-pillar.
- Pull on the LH primary rear side body seal to remove it from the vehicle.
Install
- Loosely install the LH primary rear side body seal to the body.
-
Align the joint line of the LH primary
rear side body seal to the marking on the B-pillar.
NoteMake sure the seal strings are positioned towards the interior of the vehicle when aligning the primary seal.
-
Install the clip that attaches the LH
primary rear side body seal to the upper B-pillar.
NoteMake sure the edge of the seal are parallel with and above the marking on the upper B-pillar.
- Tuck the seal into the bright molding, and make sure that it fits properly to the trim panels and the headliner.
-
Press the seal into the lower corners,
and then install the rest of the seal to the body.
NoteStretch and tuck the seal so that it is evenly distributed around the perimeter.
- Install the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).