Bracket - License Plate - Front (EMEA) (Retrofit using Jig)
Correction code 12070126 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- Andorra
- Italy
- Liechtenstein
- Monaco
- San Marino
- Switzerland
- 1694549-00-D FR LICENSE PLATE BRACKET,EU
Procedure
- Clean the front center surface of the front fascia with isopropyl alcohol (IPA) wipe, and then allow surface to dry before continuing.
- Put the front license plate bracket on the jig: Line up the 2 holes on the front license plate bracket with the alignment pins on the jig.
-
Put the jig on the front
fascia: Line up the center indicator (cut out slit) with the center of the
front fascia grille.
NoteApply enough force on the head of the jig causing an even contact surface with the front fascia grille and the front license plate bracket.NoteMake sure to hold the jig by placing your hand on the head of the jig.
-
Install the self tapping
screws (part number 1104972-00-A) (x2) that attach the front license plate
bracket to the front fascia.CAUTIONDo not over torque the screws to prevent damage to the front fascia.
- Remove the jig by sliding it out from the front fascia grille