Hose - Inlet - Power Conversion System (Remove and Replace)
Correction code
1630010132
FRT
2.64
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the postie DC link from ancillary bay. See Busbar - Fast Charge Contactor to DC Bus - Positive (Remove and Replace).
-
Release PCS coolant inlet hose from
hose clip.
-
Cut 90 degree portion of Model 3 coolant hose special tool to 2CM long.
-
Cut protrusion on the ancillary bay harness base.
-
Disconnect PCS coolant inlet hose from ancillary bay.
Install
-
Connect PCS coolant inlet hose to
ancillary bay.
-
Secure PCS coolant inlet hose to hose
clip.
- Install the postie DC link to ancillary bay. See Busbar - Fast Charge Contactor to DC Bus - Positive (Remove and Replace).