17/10/2023 18:50:59

Close Switch - Trunk (Remove and Replace)

Correction code 1511010052 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the liftgate lid trim. See Trim - Lid - Trunk (Remove and Replace).
  2. Disconnect the electrical connector from the liftgate switch.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Remove the tabs (X2) that attach the liftgate switch to the liftgate.

Install

  1. Place the liftgate switch in place and make sure that it is oriented correctly.
  2. Install the tabs (X2) that attach the liftgate switch to the liftgate.
  3. Connect the electrical connector to the liftgate switch.
  4. Install the liftgate lid trim. See Trim - Lid - Trunk (Remove and Replace).