27/02/2024 17:39:00

Trim - A-Pillar - Lower - LH (Remove and Replace)

Correction code 1518010032 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  3. Release the topmost clip on the LH lower A-pillar trim.
  4. Pull the rearmost part of the LH lower A-pillar trim upward to release the clips and tabs, and then pull the entire trim rearward to remove the trim from the vehicle.

Install

  1. Install the clips (X4) that attach the LH lower A-pillar assembly to vehicle.
  2. Install the topmost clip on the LH lower A-pillar trim.
  3. Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  4. Close the LH front door.