17/10/2023 18:49:26
Sill Plate - Front - LH (Remove and Replace)
Correction code 1205010042 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 1049517-00-A Seam Roller, Silicone, 5"
Remove
- Open the LH front door and lower the LH front window.
- Use IPA wipes to clean around the sill plate.
-
Apply masking tape around
the perimeter of the sill plate to mark the installation positioning.
NotePlace the tape as closely around the sill plate as possible.
-
Use a plastic trim tool to
carefully pry up and bend the sill plate. Pull out the door sill plate when
all adhesive is separated.
CAUTIONBe careful not to damage the vehicle trim or body.WarningThe video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
- Use IPA wipes to clean off any remaining adhesive.
Install
- Remove the adhesive backing from the new sill plate.
- Using the masking tape as a guide, carefully place the new sill plate into place and press down on it to adhere it to the vehicle.
- Use a seam roller to fully wet out the adhesive.
- Remove the protective film from the sill plate.
- Remove the masking tape from the door sill.
- Raise the LH front window and close the LH front door.