2026-08-09

GNSS Antenna (Remove and Replace)

Correction code 2135011042 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: GNSS Antenna (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the GNSS antenna to the vehicle
1 Nm (.7 lbs-ft)
  • Ratchet/torque wrench
 Reuse

Remove

  1. Remove the lower camera cover. See Camera Cover - Lower (Remove and Replace).
  2. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  3. Remove the upper camera cover. See Camera Cover - Upper (Remove and Replace).
    Note
    No need to remove the interior camera from the upper camera cover.
  4. Remove the screw and tabs (x2) that attaches the GNSS antenna to the vehicle, and then slide the antenna to the LH side to remove it from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench