18/07/2024 23:06:36

Switch - Window - Driver (Remove and Replace)

Correction code 1513021412 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. Remove the LH front door NVH pad. See NVH Pad - Door - Front - LH (Remove and Replace).
  2. Use a plastic trim tool to release the clips (x8) that attach the LH front lower bolt cover to the LH front door trim panel.
  3. Release the clips (x2) that attach the harness connector to the bolt cover.
  4. Disconnect the driver window switch electrical connector.
  5. Press down on the driver window switch assembly, and at the same time, release the clips (x4) that attach the window switch to the door trim panel.
    Tip: Use a 45 degree pick or a pocket screw driver to release the clips.
    Tip: Pull up on the manual release handle for access, and then use thumb to push down on the switch to release it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace the door trim if any tab is broken during removal.
  6. Remove the driver window switch from the vehicle.

Install

  1. Pull up on the manual release handle for access, and position the driver window switch into the vehicle, and then secure the clips (x4) that attach the switch to the door trim panel.
  2. Connect the driver window switch electrical connector.
  3. Secure the clips (x2) that attach the harness connector to the bolt cover.
  4. Secure the clips (x8) that attach the LH front lower bolt cover to the LH front door trim panel.
  5. Install the LH front door NVH pad. See NVH Pad - Door - Front - LH (Remove and Replace).