2025-03-19

Tire - Front - LH (Balance) (Rebalance)

Correction code 34022025 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Always read and understand the tire equipment operator’s manual and on-screen instructions before operating the wheel balancer or tire changer.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Always make sure to properly secure the wheel and exercise caution around all moving parts and pinch points, including the indent rollers. Additionally, secure all loose items such as hair, jewelry, and clothing, so that they will not catch on moving parts.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Wear appropriate personal protective equipment (PPE) including cut-resistant gloves and safety glasses when performing this procedure.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The machine must be operated by no more than one person at a time. Other persons must maintain a safe distance of at least three feet from equipment while in use.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Never use equipment that is defective or not working as expected based on the equipment operator’s manual.
Informational PurposesAn informational icon, calling your attention
Note
These instructions are based on the Hunter GSP9700 wheel balancer. Some steps might be different for other wheel balancers. Refer to the operator's manual and on-screen instructions for specific information.

Balance

Informational PurposesAn informational icon, calling your attention
Note
Perform this procedure once the wheel has been removed from the vehicle.
  1. Position the wheel on the balancer with the front of the wheel facing outward. If needed, install the proper inner cone adapter on the wheel balancer.
  2. Press and hold the balancer brake pedal to prevent the wheel from spinning.
  3. Secure the wheel to the balancer by tightening the balancer wing nut.
  4. Refer to the "Tire and Loading Information" label located on the driver side B-pillar, and record the correct tire pressure, depending on suspension type, tire size, and region.
  5. Use a plastic scraper tool to remove all existing wheel weights. Discard the wheel weights.
    Informational PurposesAn informational icon, calling your attention
    Note
    Thoroughly remove all adhesive residue.
  6. Input the vehicle and wheel information into the balancer.
  7. Attach the air chuck to the valve stem, then set the correct pressure on the touchscreen. The balancer automatically adjusts the tire pressure.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use the tire sticker values displayed on the lower b-pillar.
  8. Disconnect the air chuck, and then install the valve stem cap on the valve stem.
  9. Use the balancer to spin the wheel.
  10. Install new wheel weight(s) centered on the red laser line(s) projected by the balancer.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press and hold the balancer brake pedal to keep the wheel from spinning.
    Informational PurposesAn informational icon, calling your attention
    Note
    Clean the wheel surface and let dry before installing wheel weight(s).
  11. Spin the wheel again to confirm that the wheel is balanced.
  12. Remove the balancer wing nut, and then remove the wheel from the balancer.