2026-05-13

Wiper Module (RHD) (Remove and Replace)

Correction code 1750020002 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-05-13: Added pinch point warning.
Table 1. Torque Specifications: Wiper Module (RHD) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x3) that attach the wiper module to the body
7 Nm (5.2 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Open the RH front door and lower the RH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the fresh air gutter assembly. See Assembly - Fresh Air Gutter - HVAC (Remove and Replace).
  4. Remove the wiper arms. See Wiper Arm - Driver Side (Remove and Replace).
  5. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  6. Remove the bolts (x3) that attach the wiper module to the body, and then move it aside.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Disconnect the wiper module connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not place the limbs within the linkage movement area as the wiper arms will automatically transition to parking mode.
  8. Remove the wiper module from the vehicle.

Install

  1. Connect the wiper module connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not place the limbs within the linkage movement area as the wiper arms will automatically transition to parking mode.
  2. Install the bolts (x3) that attach the wiper module to the body.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  4. Install the wiper arms. See Wiper Arm - Driver Side (Remove and Replace).
  5. Install the fresh air gutter assembly. See Assembly - Fresh Air Gutter - HVAC (Remove and Replace).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  7. Raise the RH front window and close the RH front door.