2026-03-19

Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)

Correction code 1305010062 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH rear door.
  2. Lower the LH rear window.
  3. Fold down the LH 2nd row seat.
  4. Pull the 2nd row side bolster outward, and then move the bolster up to remove it from the vehicle.
    1. Carefully pull the outer edge of the 2nd row side bolster outward to release the RH upper tab first.
    2. Continue to pull the bolster outward to release the LH upper tab.
    3. Move the bolster up to remove it from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The retaining clips may become dislodged when performing this procedure. Wear eye protection to avoid personal injury.
  5. Remove and discard the bolster plastic bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bracket might have come out with the bolster.

Install

  1. Install new bolster plastic bracket to the 2nd row seat side bolster.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bracket is one time use only.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  2. Align the bottom and side tabs, and then push inward to install the bolster.
  3. Unfold the LH 2nd row seat back so that it is upright and secured.
  4. Raise the LH rear window.
  5. Close the LH rear door.