2024-08-07

HV Battery Assembly - High Voltage Battery Assembly - Vent with Shroud - Pair (Remove and Replace)

Correction code 16106486 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Perform the Vehicle HV Disablement Procedure. See Vehicle HV Disablement Procedure (Test/Adjust).
  2. Remove the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
  3. Release the fir tree clips (x2) that attach the coolant hoses to the LH shear plate.
  4. Remove the nuts (x6) that attach the LH and RH HV battery vent shroud assemblies to the HV battery.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • JOINT, UNIVERSAL, 1/4" DR
  5. Remove the LH and RH HV battery vent shroud assemblies from the HV battery.

Install

  1. Position the LH and RH HV battery vent shroud assemblies to the HV battery for installation.
  2. Install the nuts (x6) that attach the LH and RH HV battery vent shroud assemblies to the HV battery.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • JOINT, UNIVERSAL, 1/4" DR
  3. Install the fir tree clips (x2) that attach the coolant hoses to the LH shear plate.
  4. Perform platter enclosure air leak test. See Platter Enclosure Air Leak Test (Test/Adjust).