17/10/2023 18:54:10

Sensor - Cabin Temperature - Fan Driven (Remove and Replace)

Correction code 1810010122 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Sensor - Cabin Temperature - Fan Driven (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the cabin temperature sensor to the touchscreen
2 Nm (1.5 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 2 in extension
  • Torx T20 socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Open the RH front door, and lower the RH front window.
  2. Insert a plastic trim tool into the top center slot of the service panel, and then release the clips (x2) and tabs (x4) that attach the service panel to the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    An electrical harness is still connected to the service panel. Do not pull the service panel too far from the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Disconnect the electrical harness from the cabin temperature sensor.
  4. Remove the service panel from the touchscreen.
  5. Remove the bolts (x2) that attach the cabin temperature sensor to the service panel, and then remove the sensor.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 2 in extension
    • Torx T20 socket
    • Ratchet/torque wrench

Install

  1. Position the cabin temperature sensor to instrument panel service panel, and then install the bolts (x2) that attach the sensor to the service panel.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 2 in extension
    • Torx T20 socket
    • Ratchet/torque wrench
  2. Connect the temperature sensor connector, and then secure the clips (x2) and tabs (x4) that attach the service panel to the vehicle.
  3. Raise the RH front window and close the RH front door.