Harness - Front Subframe (Dual Motor) (Remove and Replace)
Correction code
1710050012
FRT
0.36
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
- 1060071-00-A Torque Wrench ¼ in Dr Hexagon
Remove
-
Place the vehicle on the 2-post lift.
NoteEnsure the vehicle is not charging.
- Open the LH front door and lower the LH front window.
- Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
- Disconnect the LV battery power. See LV Battery - Li-lon (Disconnect and Connect) (Modify).
-
Release the locking tab and push the handle downward to disconnect the
front drive unit inverter logic connector.
-
Release the front subframe harness
clips (x2) from the inverter housing.
-
Remove the front subframe harness
clips (x3) from the left side of the front subframe.
-
Release the grey locking tab, and then press on the tab to release the
front subframe harness connector.
-
Remove the front subframe harness
connector clip from the front subframe.
-
Remove the front subframe harness
clips from the front and the right side of the front subframe.
-
Disconnect the oil pump connector from the oil pump.
-
Release the front subframe harness
clip from by the resolver housing.
-
Release the front drive unit resolver
connector, and then remove the front subframe harness from the front subframe.
Install
-
Place the front subframe harness to
the front subframe, and then secure the front subframe harness clips (x2) to the
inverter housing.
-
Fully seat the connector, and then secure the locking tab to connect the
front drive unit inverter logic connector.
-
Install the front subframe harness
clips (x3) to the left side of the front subframe.
-
Install the front subframe main
harness connector clip to the front subframe.
-
Engage the grey locking tab, and then press on the tab to connect the front
subframe harness connector.
-
Install the front subframe harness
clips to the front and the right side of the front subframe.
-
Connect the oil pump connector to the oil pump.
-
Secure the front subframe harness clip
to by the resolver housing.
-
Secure the front drive unit resolver connector.
- Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
- Connect the LV battery power. See LV Battery - Li-lon (Disconnect and Connect) (Modify).
- Raise the LH front window and close the LH front door.
- Remove the lift arms from below the vehicle.