Sensor - Pressure - Door - Rear - LH (Remove and Replace)
Correction code
2020010072
0.18
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect LV power. See LV Battery - Li-lon (Disconnect and Connect) (Modify).
- Remove the rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
- Disconnect the rear door pressure sensor connector.
- Twist the tabs counterclockwise and remove the rear door pressure sensor from the closeout panel.
Install
Installation procedure is the reverse of removal.