06/05/2024 18:51:58
Axle Seal - Output - Rear Drive Unit (4DU) (Remove and Replace)
Correction code 4001010042 FRT 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 1454928-00-A - TOOL, SEAL PULLER, ADJUSTABLE
- 1131206-00-A - INSTALL TOOL, OUTPUT SEAL
Remove
- Remove the LH rear halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace).
- Use an adjustable seal puller to remove the LH rear output axle seal.
Install
-
Apply Molykote
M-77 Lubricant Paste to the outboard side of the LH rear halfshaft
assembly.
NoteClean the halfshaft before applying if necessary.NoteApply no more than 1 gram to axle only.
-
Use the output seal installation tool
to install the LH rear output axle seal.
NoteMake sure the seal is fully seated.
- Install the LH rear halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace).