Pivot Sleeve - Seat Back - 2nd Row - Center (Remove and Replace)
Correction code
1305012212
FRT
0.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.NOTE:
See Ergonomic Precautionsfor safe
and healthy working practices.
Remove
- Remove the 2nd row LH seat back assembly. See Seatback - 2nd Row - LH (Remove and Replace).
-
Release the tabs (x4) that attach the
pivot sleeve to the seat back assembly pivot pin, and then remove the sleeve from the
pin.
Install
-
Install the pivot sleeve onto the seat
back assembly pivot pin and slide it inward until the tabs (x4) are fully seated.
- Install the 2nd row LH seat back assembly. See Seatback - 2nd Row - LH (Remove and Replace).