17/10/2023 18:48:20

Fascia - Rear - Lower - Base (Remove and Replace)

Correction code 1001040022 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Fascia - Rear - Lower - Base (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x4) that attach the lower rear fascia to the upper rear fascia
3 Nm (2.2 lbs-ft)
  • 10 mm socket
  • Cordless Ratchet/Impact Driver
Reuse

Remove

  1. Remove the rear fascia diffuser. See Diffuser - Rear Fascia (Remove and Replace).
  2. Remove the bolts (x4) that attach the lower rear fascia to the upper rear fascia.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Cordless Ratchet/Impact Driver
  3. Remove the LH and RH rear fascia lamp assemblys. See Rear Fascia Light - LH (Remove and Replace).
  4. Remove the tabs (x19) that attach the lower fascia to the upper fascia.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  5. Remove the lower fascia.

Install

  1. Install the tabs (x19) that attach the lower fascia to the upper fascia from either side.
  2. Install the LH and RH rear fascia lamp assemblys. See Rear Fascia Light - LH (Remove and Replace).
  3. Install the bolts (x4) that attach the lower rear fascia to the upper rear fascia.
    3 Nm (2.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Cordless Ratchet/Impact Driver
  4. Install the rear fascia diffuser. See Diffuser - Rear Fascia (Remove and Replace).