17/10/2023 18:57:09

Tube Assembly - Charge Port (Remove and Replace)

Correction code 4401010032 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH trunk load floor. See Load Floor - Trunk (Remove and Replace).
  2. Remove the trunk garnish. Garnish - Trunk (Remove and Replace).
  3. Remove the trunk sill trim. See Trim - Trunk Sill (Remove and Replace).
  4. Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  5. Disconnect the LH trunk task light connector.
  6. Use a pry tool to remove the clip that attaches the LH trunk side trim to the vehicle.
  7. Move the LH trunk side trim aside.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful to avoid excessive crease.
  8. Remove the elbow from the vehicle and the charge port outlet hose.
  9. Remove the charge port outlet hose from the vehicle.

Install

  1. Install the charge port outlet hose to the vehicle.
  2. Install the elbow to the charge port outlet hose.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to install the corresponding side of the elbow to the charge port outlet hose.
  3. Install the elbow to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the elbow is fully seated.
  4. Connect the LH trunk task light electrical connector.
  5. Install the clip that attaches the LH trunk side trim to the vehicle.
  6. Install the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  7. Install the trunk sill trim. See Trim - Trunk Sill (Remove and Replace).
  8. Install the trunk garnish. Garnish - Trunk (Remove and Replace).
  9. Install the LH trunk load floor. See Load Floor - Trunk (Remove and Replace).