Correction code 2020010012 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning

Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see .

Table 1. Torque Specifications: Sensor - Impact Accelerator - Front Bumper - Center (Remove and Replace)

Description	Torque Value	Recommended Tools	Reuse/Replace	Notes
Bolts that secure the washer tank to the front end carrier	3 Nm (2.2 lbs-ft)	2 in extension 10 mm socket Cordless Ratchet/Impact Driver Ratchet/torque wrench	Reuse
Bolt that secures the sensor to the vehicle	10 Nm (7.4 lbs-ft)	Flex head ratchet/flex head torque wrench 10 mm socket Ratchet/torque wrench	Reuse