17/10/2023 18:50:37
Duct - Air Wave - LH (Remove and Replace)
Correction code
1405030022
FRT
1.02
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH upper thermistor duct. See Thermistor - Duct (Remove and Replace).
-
Remove the push clips (x2)
that attach the LH air wave duct to the cross bar beam, and then remove the
duct from the HVAC assembly.
Install
-
Install the push clips (x2)
that attach the LH air wave duct to the cross bar beam.
- Install the LH upper thermistor duct. See Thermistor - Duct (Remove and Replace).