Gearbox Seal - Rear Drive Inverter (3DU) (Remove and Replace)
Correction code
4020010032
FRT
2.76
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the drive inverter assembly from vehicle. See Rear Drive Inverter (3DU) (Remove and Replace).
-
Carefully place inverter on ESD safe mat.
CAUTIONDo not place inverter facing downwards on the circuit board as it is fragile.
- Remove seal from drive inverter.
Install
- Install the seal to drive inverter.
- Install the drive inverter assembly to vehicle. See Rear Drive Inverter (3DU) (Remove and Replace).