Air Vent - Driver (Remove and Replace)
Correction code
1405030052
FRT
1.62
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2026-02-10: Updated the screw torque value securing the vent to the IP carrier and added HVAC routines after replacement.
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Screw that attaches the LH front vent to the instrument panel carrier |
 0.9 Nm (8 lbs-in) |
|
Reuse |
Remove
- Remove the driver air vent. See Air Vent - Driver (Remove and Install).
Install
- Install the driver air vent. See Air Vent - Driver (Remove and Install).
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): TEST-SELF_VCRIGHT_X_HVAC-CASE-ACTUATORSvia Toolbox:(link)
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): TEST-SELF_VCRIGHT_L_HVAC-VANE-ACTUATORvia Toolbox:(link)
- Exit Service Mode. See Service Mode.
- Raise the LH front window and close the LH front door.