23/01/2024 05:37:33

Shell - Seat Back - Front Seat (Remove and Replace)

Correction code 1307010052 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Remove the driver headrest trim from the seat. See Headrest - Front Seat (Remove and Replace).
  2. Move the LH front seat to most forward and upward position.
  3. Release the strap clips (x2) from the lower section of the driver seat back shell.
  4. Release the clips that attach the driver seat back shell to the driver seat.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the shell away from the top of the seat, when the side clips are free, pull the bottom and carefully roll the bottom tabs out of the slots.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Install

  1. Position the driver seat back shell onto the seat back, and then fasten the clips that attach the seat back shell to the seat back.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the lower clips first, and then rotate the shell up into position. Apply light pressure to ensure the seat back shell is fully seated.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  2. Hook the strap clips (x2) onto the driver seat back shell assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the straps are tight for proper fit and installation.
  3. Install the driver headrest trim. See Headrest - Front Seat (Remove and Replace).