Harness - HVAC (Remove and Replace)
Correction code
1810010062
FRT
2.64
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the HVAC assembly. See HVAC Assembly (Remove and Replace).
-
Disconnect the LH evaporator
thermistor connector.
-
Disconnect the LH lower duct
thermistor connector.
-
Disconnect the RH lower duct
thermistor connector.
-
Disconnect the lower mode actuator
connector.
-
Disconnect the upper mode actuator
connector.
-
Disconnect the intake actuator
connector.
-
Release the tabs (x4) that attach the
HVAC harness to the left of the HVAC assembly.
-
Release the tabs (x2) that attach the
HVAC harness to the top of the HVAC assembly.
-
Release the clips (x3) that attach the
HVAC harness to the upper right of the HVAC assembly.
-
Release the tabs (x4) that attach the
HVAC harness to the right of the HVAC assembly, and then remove the harness from the
vehicle.
Install
-
Position the HVAC harness onto the
HVAC assembly.
NoteUse connectors to confirm the harness position.
-
Secure the tabs (x4) that attach the
HVAC harness to the right of the HVAC assembly.
-
Fasten the clips (x3) that attach the
HVAC harness to the upper right of the HVAC assembly.
-
Secure the tabs (x2) that attach the
HVAC harness to the top of the HVAC assembly.
-
Secure the tabs (x4) that attach the
HVAC harness to the left of the HVAC assembly.
-
Connect the lower mode actuator
connector.
-
Connect the upper mode actuator
connector.
-
Connect the intake actuator
connector.
-
Connect the LH evaporator thermistor
connector.
-
Connect the LH lower duct thermistor
connector.
-
Connect the RH lower duct thermistor
connector.
- Install the HVAC assembly. See HVAC Assembly (Remove and Replace).