Thermistor - Duct (Remove and Replace)
Correction code
1405030042
FRT
1.14
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
- 2024-04-03: Fixed the broken links.
Remove
- Remove the IP carrier. See IP Carrier (Remove and Install).
-
Disconnect the thermistor connector
from LH IP air wave duct.
-
Remove the thermistor duct from LH IP
air wave duct.
Install
-
Install the thermistor duct to LH IP
air wave duct.
-
Connect the thermistor connector to LH
IP air wave duct.
- Install the IP carrier. See IP Carrier (Remove and Install).