30/10/2023 01:15:22

Shear Plate - Rear Subframe - LH (Remove and Replace)

Correction code 3001020022 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.
  2. Remove the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
  3. Use an underhoist stand to support the front portion of the rear subframe.
  4. Release the fir tree clips (x2) that attach the coolant hoses to the LH shear plate.
  5. Remove the smaller bolts that attach the LH shear plate to the HV battery.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 3 in extension
    • 13 mm socket
  6. Remove and discard the larger bolt that attaches the LH shear plate and rear subframe to the body, and then remove the LH shear plate.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 3 in extension
    • 21 mm sleeved deep socket

Install

  1. Install the LH shear plate to the rear subframe and HV battery, and then hand-tighten a new bolt to attach the shear plate to the subframe.
  2. Hand-tighten the smaller bolts that attach the LH shear plate to the HV battery.
  3. Torque the larger bolt that attaches the LH shear plate to the vehicle, and then mark the bolt with a paint pen after torquing.
    130 Nm (95.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 3 in extension
    • 21 mm socket
  4. Torque the smaller bolts that attach the LH shear plate to the HV battery.
    35 Nm (25.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • 3 in extension
    • 13 mm socket
  5. Fasten the fir tree clips that attach the coolant hoses to the LH shear plate.
  6. Remove the underhoist stand from under the vehicle.
  7. Install the rear aero shield panel. See Panel - Aero Shield - Rear (Remove and Replace).
  8. Remove the vehicle from the lift. See GUID-0ECF2493-88F6-48E9-ADBB-9AE1D52E217C.html.