Trunk Sill Trim (Model 3 Standard) (Remove and Replace)
Correction code
15180108302
15180108301
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2025-10-08: Released new procedure.
Remove
-
Open the trunk from the exterior
switch.
-
Remove the load floor.
TipUse the pull tab located at the rear edge of the panel.
-
Remove the trunk sill trim
assembly.
NotePull the corner upward to release the clip on the end, then pull away from the body to release the remaining clips (x3).
Install
-
Install the trunk sill trim
assembly.
NoteAlign the striker with the center slot, then align the 2 locators to the slots. Press to secure the clips (x4).
-
Move the seal to overlap the trim.
-
Install the load floor.
- Close the trunk.