2026-02-03

Sill Plate - Rear - LH (Model 3 Standard) (Remove and Replace)

Correction code 12050102102 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Use IPA wipes to clean around the sill plate.
  3. Use a plastic trim tool to carefully pry up the edge of the sill plate. Pull out the door sill plate when all adhesive is separated.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the vehicle trim or body.
  4. Use IPA wipes to clean off any remaining adhesive.

Install

  1. Remove the adhesive backing from the new sill plate.
  2. Carefully place the new sill plate into place and press down on it to adhere it to the vehicle.
  3. Raise the LH rear window and close the LH rear door.