11/09/2024 14:29:30

TPMS (Sensor ID Tool Learn)

Correction code 34041100 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-09-11: Added note with links to update TPMS Tool firmware.
  • 1551666-00-B Bluetooth TPMS Tool
Informational PurposesAn informational icon, calling your attention
Note
For instructions on how to update the firmware on the TPMS Wake Tool, refer to the manufacturer’s instructions. Tesla employees can refer here for the TT02 tool and here for the TT03 tool.

Procedure

  1. Press the Power button and watch the display.
  2. In the Main Menu, use the up and down arrows to select TPMS CHECK, then press the OK button.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Use the TPMS service tool to read and record the four wheel sensor IDs.
    Informational PurposesAn informational icon, calling your attention
    Note
    Hold the tool near the valve stems on the tires, and then press and hold the Read button until the sensor IDs are shown.
  4. Open the LH front door and lower the LH front window.
  5. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  6. In Toolbox 3, type "TPMS" into the search field, click PROC_TPMS_X_TPMS-SENSOR-LEARNvia Toolbox: (link)via Service Mode Plus:
    • Chassis ➜ TPMS ➜ Learn ID
    • Chassis ➜ TPMS ➜ Learn ID
    , click Run, and allow the routine to complete.
  7. Update the TPMS sensor IDs with the values from the TPMS service tool.
  8. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).
  9. Exit the service mode. See Service Mode.
  10. Raise the LH front door and close the LH front door.
  11. Test drive the vehicle to at least 15 mph for a short distance to confirm all four sensor values are shown in the UI.