Camera - B-Pillar - Pair (Inspect) (Test/Adjust)
Correction code
1722040040
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how
they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection
to make sure wearing proper PPE when performing the below procedure.
NOTE: See Ergonomic Precautions for safe and
healthy working practices.
- 2026-01-14: Released new procedure.
Special tools required for this procedure:
- 1083742-01-A CLEANER, GLASS SPRAY, FORCH, 400ML
- 1133681-01-A Microfiber cloth (x2)
- 2279425-00-A Adjustable Focus Torch
Inspect
-
Clean the outside surface of
the LH B-pillar applique.
NoteUse Zep windshield cleaner and use two microfiber cloths. Apply Zep windshield cleaner onto one microfiber towel, and then clean the outside surface. While the surface is still wet, wipe B-pillar applique with a 2nd microfiber towel thoroughly until its dry. Wipe in circular motion. Make sure that the B-pillar applique has no stains or residue.
-
Inspect the outside surface
of the LH B-pillar applique
NotePerforming the inspection indoors or in a shaded area when performed outdoors. Make sure that the vehicle is at a non-humid environment and cabin or body temperature matches the room temperature. Use the LED flash light to illuminate the applique around the camera area. Inspect and make sure that the entire area is free of any hazing, fogginess, stains and residue,. If not confident about the presence of haze, smudges or residue, then proceed to remove components to inspect the inside surface.TIp
- Repeat the above steps for the RH B-pillar camera applique.