22/11/2023 23:56:59

Fender Assembly - Front - LH (Remove and Replace)

Correction code 1010025082 FRT 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the front fender assembly. See Fender Assembly - Front - LH (Remove and Install).
  2. Apply protective tape to the LH front fender around the LH front side repeater assembly.
  3. Release the tabs (x3) that attach the LH front side repeater assembly to the LH front fender, and then separate the assembly from the fender.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the rearmost tab first.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, take care not to damage the mounting tabs.
  4. Release the clip that attaches the LH cowl screen carrier bracket to the old LH front fender, and then remove the bracket from the fender.
  5. Remove the headlight grommet from the old LH front fender.
  6. Remove the underhood storage unit clips (x3) from the old LH front fender.

Install

Tip: For instructions on how to align the fender, refer to Fender Alignment.
  1. Install the underhood storage unit clips (x3) on the new LH front fender.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any broken or damaged clips.
  2. Install the headlight grommet on the new LH front fender.
  3. Position the LH cowl screen carrier bracket on the new LH front fender, and then install the clip that attaches the bracket to the fender.
  4. Secure the upper portion of the LH front side repeater assembly into the LH front fender, and then fasten the tabs (x3) that attach the assembly to the fender.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, make sure the mounting tabs are not damaged. If any of the tabs are damaged, replace the repeater.
    Informational PurposesAn informational icon, calling your attention
    Note
    After installation, confirm that the tabs are firmly engaged.
  5. Remove the protective tape from the LH fender around the LH front side repeater assembly.
  6. Install the front fender assembly. See Fender Assembly - Front - LH (Remove and Install).